Hydraulic Cylinder Welded Type
ACE Automation LLC offers wide range of welded hydraulic cylinders, cylinders can be selected from standard list or to be maid custom.
-
Maximum working pressure 295 bar.
-
Bore diameters available from 25mm to 320mm.
-
Test pressure 350 bar unless otherwise stated.
-
Can be used as Double-acting, Single-acting pull or Single-acting push.
-
Cylinder material: ST52.3 DOM and CDS tube DIN2393 I.S.O. H8 & H9.
-
Headbush material: Cast Iron - UNI5007–G25 unless otherwise stated.
-
Rod material: Standard Grade EN8 DIN UNI CK45, Hard Chrome Plated, minimum 25 microns.
Additional / Alternative options,
-
Fully upgradeable to marine specification.
-
350 bar Heavy Duty range of cylinders.
-
Alternative rod and bore combinations available.
-
Full range of alternative rod materials available, such as : NIKROM 500 View Spec sheet, Chrome plated Stainless Steel grades 431S29T / 316L / 304.
-
Fully Stainless Steel options available.
With Spherical Bearing
A range of welded cylinders mounted on self-aligning spherical bearings
-
Welded spherical bearing on rear and front of cylinder
-
Welded spherical bearing on rear and threaded on front of cylinder
With Fork
A range of welded cylinders mounted on fork clevis
-
Welded fork clevis on rear and front of cylinder
-
Welded fork clevis on rear and threaded on front of cylinder
Rear Pin Mounted
A range of welded cylinders with rear pin hole
-
Rear pin hole and male threaded front of cylinder
-
Rear pin hole and male spherical bearing front of cylinder
-
Rear pin hole and clevis front of cylinder


